uc100 cnc usb controller usb to parallel adapter for mach3 cnc router

However modern PCs, especially laptops, don't have the old-fashioned 25-pin parallel ports and they aren't supported under modern Windows either. on a CD or downloaded from the NFS website), it has a 'plugin' that converts commands from the main program into pulses to drive the stepper drives and output these through the parallel port. Now, where did the Mach3 software you have come from? As supplied (e.g. (I have a Huawei Matebook Pro that is 2 years old and it doesn't have any Ethernet ports either, though actually I have a mini Win10 machine for the CNC.)

Is this correct? I can't see why this should give any problems, if it supports general Ethernet connections up to 1 Gbps I doubt that Mach 3 can throw anything it can't handle. So I would guess that you have USB-C ports, which are quite fast enough to support Ethernet up to 1 Gbps, and a USB-Ethernet 'dongle'. I would guess that you have a modern laptop that doesn't have an integral Ethernet port - this is quite common these days since the Ethernet connector is too high for thin laptops. Please could you tell us which driver you have? It might help to look at their website at - it's probably either a UC300ETH or UC400ETH. So hopefully there is light at the end of the tunnel for you!įrom what you say you have a CNC Drive Ethernet motion controller (that is, the connection to your laptop is via Ethernet).

I therefore think that Win11 should work. Hi Ts, I guess we are not being very helpful but we don't have a lot of information to work from!įirst, I have recently upgraded to using Mach 3 under Windows 10 using CNC Drive components and it was fairly painless.

Uc100 cnc usb controller usb to parallel adapter for mach3 cnc router